Removal and Installation

REAR AXLE SHAFT ASSEMBLY

REMOVAL
1. Remove the disk brake and parking brake assembly.
2. Remove the parking brake cable and speed sensor cable.





3. Remove the rear axle shaft mounting bolt.





4. Remove the rear axle shaft.





5. Using the special tool(O9526-11100), remove the oil seal.

INSTALLATION
1. Installation is the reverse of removal.
2. Apply grease to the oil seal lip.





3. Using the special tools (O9500-11000, 09532-11500), install the oil seal.





4. After installing the axle shaft, tighten the nut.
Tightening torque: 43 - 60 Nm (4.4 - 6.2 kg-m, 32 - 44 ft. lbs.)
5. Adjust the parking brake lever stroke.