Component Inspection
Component Inspection
Check Related Component.
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
4. Check if the DTC is erased while disconnecting related component one after another.
** Related component :IPM, ADM, DDM, FAM, RAM, IMS, Cluster module.
5. Is the DTC erased ?
YES
1) Substitute with a known-good pertinent component and check for proper operation.If the problem is corrected, replace pertinent component and then go to "Verification of Vehicle Repair" procedure.
NO
1) Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.