W/Harness Inspection

Terminal and Connector Inspection

1. Electrical systems consist of a lot of harness and connectors, poor connection of terminals can cause various problems and damage of component.
2. Check poor connection, beding, corrosion, contamination, deformation of connector and it terminals.
3. Is any problem found ?
YES
1) Repair if necessary and go to "Verification of Vehicle Repair".
NO
1) Go to W/Harness Inspection.

Signal Circuit Inspection

Check short in signal circuit
1. Ignition "ON" & engine "OFF"
2. Disconnect rear wiper motor.
3. Measure the resistance between rear wiper motor signal circuit connector terminal at RAM side (BCM-RR2-6) and chassis ground.
A. Specification : Infinity Ohms




4. Is the measured resistance within the specification ?
YES
1) Go to "Component Inspection".
NO
1) Repair open in power circuit and Go to "Verification of Vehicle Repair".