Operation CHARM: Car repair manuals for everyone.

Monitor Scantool Data





Monitor Scantool Data

1. IG "OFF" & connect scantool.
2. ENG "ON" and warm-up the engine to normal operating temperature.
3. Monitor "CAM (B1)" status on the service data.








4. Are the "CMP (B1)" data displayed correctly ?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure
NO
1) Go to W/Harness Inspection - "Terminal and connector inspection" procedure