Operation CHARM: Car repair manuals for everyone.

Monitor Scantool Data





Monitor Scantool Data

1. Connect Scantool then Engine "ON"
2. Warm up the engine to normal operating temperature.
3. Monitor the signal waveform of HO2S (B1S2) with scantool
Specification : 0.1 - 0.9V




4. Is the shift time from signal waveform within specifications ?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure
NO
1) Go to W/Harness Inspection - "Terminal and connector inspection" procedure