Monitor Scantool Data
Monitor Scantool Data
1. Connect Scantool to Data Link Connector (DLC).
2. ENG "ON"
3. Monitor "Fuel Pump Relay" item on the scantool.
4. Is the service data displayed correctly ?
YES
1) Fault is intermittently caused by poor contact in the sensor and/or PCM connector or non cleared PCM memory after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace if necessary and go to "Verification of vehicle Repair".
NO
1) Go to W/Harness Inspection - "Terminal and connector inspection" procedure.
2) In case of open in Main Relay, this DTC can be set. so, check it for open before going next procedure. P0562