Operation CHARM: Car repair manuals for everyone.

Monitor Scantool Data





Monitor Scantool Data

1. Connect scantool to DLC. (Data Link Connector)
2. IG "ON" & ENG "OFF"
3. Monitor "Throttle Position Sensor" by stepping on and off the accelerator pedal on scantool




4. Are those parameters related to "TPS" operating correctly ?
YES
>Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure
NO
>Go to "System Inspection" procedure.