Operation CHARM: Car repair manuals for everyone.

Monitor Scantool Data





Monitor Scantool Data

1. Connect scantool to DLC (Data Link Connector).
2. Warm up the engine to normal operating temperature.
3. Monitor "APS1 & APS2" parameters on the scantool.









4. Are those "APS1 & APS2" parameters displayed correctly ?
YES
>Fault is intermittent caused by poor contact in Sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure
NO
>Go to W/Harness Inspection - "Terminal and connector inspection" procedure.