Cylinder Block

REMOVAL

CAUTION:
a. Use fender covers to avoid damaging painted surfaces.
b. To avoid damage, unplug the wiring connectors carefully while holding the connector portion.

NOTE:
a. Mark all wiring and hoses to avoid misconnection.
b. Inspect the timing chain before removing the cylinder head.
c. Turn the crankshaft pulley so that the No.1 piston is at top dead center.
d. Engine removal is required for this procedure.

1. Remove exhaust manifold.
2. Remove intake manifold.
3. Remove timing chain.
4. Remove water temperature control assembly.
5. Remove cylinder head.
6. Remove oil pump.
7. Remove oil filter assembly.
8. Remove A/C compressor(A) from engine.




9. Remove generator(A) from engine.




10. Remove power steering pump(A) from engine.






INSTALLATION

1. Install power steering pump.
2. Install generator.
3. Install air conditioner compressor
4. Install oil filter assembly.
5. Install oil pump.
6. Install cylinder head.
7. Install water temperature control assembly.
8. Install timing chain.
9. Install intake manifold.
10. Install exhaust manifold.