Monitor Actuation Test

Monitor Actuation Test

1. Connect scantool to Data Link Connector (DLC)
2. Ignition "ON" & Engine "OFF".
3. Select the "Actuation Test" mode on the scantool.
4. Inspect operating status of Rear left valve (in) with Actuation Test.
A. Specification : It's normal if operating sound is heard.




5. Does a Rear left valve (in) operate normally ?
YES
1) Fault is intermittent caused by faulty valve or was repaired and HECU memory was not cleared. Go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "W/Harness Inspection" procedure.