PSD
B2426Component Location:
General Description
Power sliding door (hereinafter PSD) is the system which moves sliding door of vehicle by electronic motor so that user can open or close door with less force than required on manual operation. PSD consists of drive unit, center roller/rail, handle and various kinds of switch (anti pinch, detent, latch), anti pinch switch is secondary protection equipment that prevents nipping in the door and has steel point of contact in rubber strip. When an obstacle has been detected during a power closing operation, the PSD shall reverse direction and move to the full open position (When an obstacle is detected during a power opening operation, the PSD shall stop)
DTC Description
The ECM sets DTC B2426 if there's short in anti pinch sensor signal harness.
DTC Detecting Condition:
Schematic Diagram:
Monitor Scantool Data
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF" & PSD "ON"
3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
4. Is the DTC B2426 present?
YES - Go to "Inspection & Repair" procedure.
NO - Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
Terminal and Connector Inspection
1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
YES - Repair as necessary and go to "Verification Vehicle Repair" procedure.
NO - Go to "W/Harness Inspection" procedure.
Signal Circuit Inspection
1. Check for short in harness
1. Ignition "ON" & engine "OFF"
2. Measure resistance between terminal "D44-1.D54-1" of APS and chassis ground.
Specification : Approx. 0 ohm
3. Is the measured resistance within specifications?
YES - Go to "Component Inspection" procedure.
NO - Check for short in power harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
Component Inspection
1. Check PSD
1. Ignition "ON" & engine "OFF" & PSD "ON"
2. Measure voltage between terminal "F28-2-7, F27-2-7" of PSD and chassis ground
Specification : Approx. 3.95 - 6 V
3. Is the measured voltage within specifications?
YES - Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO - Substitute with a known-good PSD and check for proper operation.
If the problem is corrected, replace PSD and then go to "Verification of Vehicle Repair" procedure.
Verification of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
2. Operate the vehicle and monitor the DTC on the scantool.
3. Are any DTCs present?
YES - Go to the applicable troubleshooting procedure.
NO - System is performing to specification at this time.