DDM
B2525Component Location:
General Description
DDM is a node of CAN communication system which consists of IPM. FAM, RAM, ADM, IMS. Main function of DDM is lock/unlock of door and window, adjusting position and fold/unfold of outside mirror. Beside that, for for the convenience of driver in dark area, DDM controls all sorts of switch illumination (outside mirror s/w, front power seat s/w etc.) and door lamp.
DTC Description
The ECM sets DTC B2525 if there's short circuit in illumination circuit harness
DTC Detecting Condition:
Schematic Diagram:
Monitor Scantool Data
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
4. Is the DTC B2525 present?
YES - Go to "Inspection & Repair" procedure
NO - Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
Terminal and Connector Inspection
1. Many malfunctions in the electrical system are caused by poor harness and terminals
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
YES - Repair as necessary and go to "Verification Vehicle Repair" procedure
NO - Go to "W/Harness Inspection" procedure
Power Supply Circuit Inspection
Motor Power circuit Inspection
1. Ignition "OFF"
2. Disconnect outside mirror switch and front power seat switch
3. Measure resistance between terminal "1" of DDM and chassis ground
Specification : Approx. Infinity ohms
4. Is the measured resistance within specifications?
YES - Go to "Component Inspection" procedure.
NO - Check for short in power harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
Component Inspection
Check illumination
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Select 'ACTUATION TEST' mode on scantool and press [F1] to start
4. Does illumination lamp work properly?
YES - Go to "Check DDM" procedure.
NO - Substitute with a known-good illumination lamp and check for proper operation.
If the problem is corrected, replace illumination lamp and then go to "Verification of Vehicle Repair" procedure.
Check DDM
5. Connect scantool to Data Link Connector (DLC).
6. Ignition "ON" & engine "OFF"
7. Substitute with a known-good DDM and Check if the DTC is erased
8. Is the DTC erased?
YES - Substitute with a known-good DDM and check for proper operation.
If the problem is corrected, replace DDM and then go to "Verification of Vehicle Repair" procedure.
NO - Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
Verification of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC
2. Operate the vehicle and monitor the DTC on the scantool
3. Are any DTCs present?
YES - Go to the applicable troubleshooting procedure
NO - System is performing to specification at this time.