General Information

Component Location





General Description

This is DTC which is related with communication error between IPM and other units.
(** Control Units : IPM (Inter Panel Module), FAM (Front Area Module), PDM (Power Distribution Module), DDM (Drive Door Module), ADM (Assist Door Module), CLU (Cluster), PSM (Power Seat Module), SCM (Steering Control Module), RAM (Rear Area Module), SMK (Smart Key)
* CAN (Controller Area Network) : CAN is serial bus communication type which links not only communication system but also control units each other.
*2 LIN (Local Interconnect Network) : LIN is serial communication type which is used in electrical control system.






DTC Description

If the abnormal signal is received from MF Wiper SW to IPM for 2 seconds, for instance, Both Wiper low and Wiper high signal inputted together, IPM sets DTC.

DTC Detecting Condition





Diagnostic Circuit Diagram