Inspection/Repair - W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Power Circuit Inspection

Defog in Driver rear view mirror
1. IG "ON" & ENG "ON"
2. Make ON status with turning ON the defog switch for outside rear view mirror of Driver side.
3. Check voltage between signal terminal of outside rear view of Driver side goes to ADM and chassis ground.

Specification : About 12V





4. Is the measured value within specification ?