Inspection/Repair - W/Harness Inspection
Terminal and Connector Inspection
1. Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
Left Turn Signal Lamp Circuit Inspection
Check short to ground in harness
1. IG "OFF", disconnect battery (-) terminal.
2. Disconnect FAM connector.
3. Measure resistance between the Left turn signal lamp terminal of FAM harness connector and ground of the left turn signal lamp.
Specification : Approx. 1 Ohm
4. Is the measured resistance within specification?