Component Inspection

Component Inspection

Check TCM
1. Ignition "ON" & Engine "OFF".
2. Disconnect the "ATM Control Unit (CLG01-A)" connector.
3. Install scantool and select a voltage/signal simulation mode,
4. Simulate voltage (0 ->5V) to "TRANSMISSION FLUID TEMPERATURE SENSOR 1, 2" signal circuit.








Fig 1) Simulation Output 1.00 V -> 63°C (145°F)
Fig 2) Simulation Output 2.00 V -> 33°C (91°F)
** It is subject to change vehicle condition.
5. Is FLUID TEMP. SENSOR signal value changed according to simulation voltage?