Scantool Diagnostics

Monitor Scantool Data

Stall Test
** It is difficult to do "STALL TEST" in 3rd gear, therefore Go to "Signal Check" as follow
Signal Check
1. Connect Scantool.
2. Engine "ON".
3. Monitor the "INPUT & OUTPUT SPEED SENSOR" parameter on the scantool.
4. Accelerate the Engine speed until about 2000 rpm in the 3rd gear.

Specification : INPUT SPEED - (OUTPUT SPEED • 3rd GEAR RATIO) ≥ 200 rpm





5. Does "INPUT & OUTPUT SPEED SENSOR" within specifications?