Repair Procedures

Removal

1. Remove the rear roof trim .
2. Disconnect the cable and connector(A) from the SDARS roof antenna.




3. Remove the SDARS roof antenna(B) after loosening the nut(A).






Installation

1. Install the roof antenna to the roof panel.

Tightening torque (Nut)
4 - 8 N.m (0.4 - 0.8 Kg.m, 2.9 - 5.8 lb-ft)


2. Reconnect the cable and connector to the roof antenna.
3. Install the rear roof trim.

NOTE:
- Make sure the speaker connectors are plugged in properly.
- Check the audio system.