Repair Procedures

Removal

CAUTION:
Head lamps become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off.

NOTE:
The headlamp bulb should not be removed from the headlamp assembly until just before a new bulb is installed.
Removing bulb for an extended period of time may affect headlamp bulb performance.
Contaminants may enter the headlamp assembly where they can settle on the lens and reflector.
Never turn on the head lamps with the bulb removed from the headlamp assembly.

1. Disconnect the negative (-) battery terminal.
2. Loosen the mounting bolts (2EA) of head lamp assembly (A).




3. Disconnect the head lamp connector (A).




4. Loosen the front bumper upper support bracket bolt (A).




5. Loosen the bumper mounting screw from the side spacer to make easier to remove the head lamp assembly.




6. Remove the head lamp bulb after removing the head lamp assembly.
(1. Head lamp low beam, 2. Head lamp high beam, 3. Turn signal lamp, 4. Side marker)





NOTE:
Take care that retaining clip (A) is not to be damaged.




7. Release the lock of the set spring (A) to remove the head lamp high beam bulb.




8. Remove the head lamp high beam bulb(A).




9. Remove the head lamp low beam cap(A) by turning in the counter clock-wise direction.




10. Remove the head lamp low beam bulb(A).




11. Remove the turn signal lamp bulb(A) by turning in the counter clock-wise direction.






Installation

1. Install the head lamp bulbs.
2. Reassemble the head lamp bulb caps.
3. Reassemble the head assembly after connecting the lamp connector.
4. Reassemble the front bumper upper support bracket bolts.