Repair procedures

Replacement

1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2. Remove the rear wheel and tire from rear hub.

CAUTION:
Be careful not to damage to the hub bolts (C) when removing the rear wheel and tire (A).

3. Remove castle nut(A) from the front hub under applying the break.

Tightening torque :
240.2 - 269.6N.m(24.5 - 27.5Kgf.m, 177.2 - 198.9lb.ft)





4. Remove the rear strut assembly mounting bolt(A).




5. Remove the assist arm(A) and the trailing arm(B) from the rear axle carrier









NOTE:
Remove the rear assist arm ball joint by using the special tool(09568-4A000).




6. Remove the rear stabilizer link(A) from the rear axle carrier.




7. Remove the brake caliper mounting bolts (A), and then place the brake caliper assembly (B) with wire as shown in the illustration.

Tightening torque :
83.3 - 98.0N.m(8.5 - 10.0Kgf.m, 61.4 - 72.3lb.ft)





8. Remove the wheel speed sensor(A) and the parking brake cable(B) from the rear axle carrier.




9. Disconnect the rear shaft end(A) from knuckle.




10. Remove the cotter pin and the castle nut (A) from the rear upper arm ball joint(B), and then remove the rear upper arm ball joint (B) by using the special tool(09568-34000).








11. Remove the hub assembly mounting bolts(B) from the rear axle carrier (A).








12. Install in the reverse order of removal.