Monitor Scantool Data

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF" & PTG "ON" & Close tail gate.
3. Monitor the "Door/Gate Open Feedback" and "Door/Gate Close Feedback" Parameter on the Scantool While pushing "OPEN" switch.
A. Specification :
if 'Door/Gate Open Feedback' > 9V -> 'Door/Gate Close Feedback'>8V
if 'Door/Gate Open Feedback' < 8V -> 'Door/Gate Close Feedback'<9V




4. Is the measured current data within specifications?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "Inspection & Repair" procedure.