Component Inspection

Component Inspection

1. Check door motor
1. Ignition "ON" & engine "OFF"
2. Disconnect door motor.
3. Connect (+) terminal of battery to terminal 1 of door motor and (-) terminal to terminal 2 of door motor.
4. Connect (+) terminal of battery to terminal 2 of door motor and (-) terminal to terminal 1 of door motor.




5. Dose the door motor work properly?
YES
1) Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Substitute with a known-good drive unit and check for proper operation.
If the problem is corrected, replace drive unit and then go to "Verification of Vehicle Repair" procedure.

CAUTION:
** It is impossible to change door motor separately. So it is changed by drive unit when change is necessary.