System Inspection
System Inspection
1. Check CMPS
(1) IG "OFF" & Disconnect CMPS connector.
(2) IG "ON" & Measure voltage between terminal 1,2 & 3 of CMPS (B2) harness connector and chassis ground.
A. Specification :
Terminal 1. approx. 5V
Terminal 2. approx. below 1V
Terminal 3. approx. 5V
(3) Is the measured voltage within specification?
YES
- Go to Check "CKPS" as follow.
NO
- Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
2. Check CKPS
(1) IG "OFF" and disconnect CKPS connector.
(2) IG "ON" & Measure voltage between terminal 1 & 2 of CKPS harness connector and chassis ground.
A. Specification : Approximately 1.4V
(3) Is the measured voltage within specification?
YES
-Go to "component Inspection" procedure.
NO
-Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.