Component Inspection

Component Inspection

1. Check ECTS
2. IG "OFF" and disconnect ECTS connector.
3. Measure resistance between terminals 1 and 3 of ECTS connector as the temperature rises.
Specification :









4. Are the measured resistance within specification?
YES
- Clear DTC and Test-drive under enable conditions above-mentioned.
After the test, If this DTC is set, recheck it thoroughly. If not, it is intermittent fault, go to "Verification of vehicle Repair" procedure.
NO
- Substitute with a known - good ECTS and check for proper operation.
If the problem is corrected, Go to "Verification of Vehicle Repair"procedure.