Monitor Scantool Data
Monitor Scantool Data
1. IG "OFF" & amp; connect scantool.
2. ENG "ON" and warm -up the engine to normal operating temperature.
3. Monitor items related to Ignition on the service data.
Specification : BTDC 10 ° ± 5 °
4. Is the service data displayed correctly?
YES
- Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure
NO
- Go to "Terminal and Connector Inspection" procedure