Operation CHARM: Car repair manuals for everyone.

Monitor Scantool Data





Monitor Scantool Data

1. Engine "ON".
2. Connect scantool to Data Link Connector (DLC).
3. Start and drive vehicle in gear and maintain vehicle speed is approx. 10 km/h or more (6 mph or more)
4. Monitor the "WHEEL SPD SNSOR" parameter on the Scantool.
A. Specification : Compare with another parameters related to wheel speed sensor.
If it is the same as another parameters, it is in normal condition.




5. Is parameter displayed within specifications?
YES
1) Fault is intermittent caused by poor connection in wheel speed sensor harness, Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.
Repair as necessary and then go to "Verification of vehicle Repair" procedure.
NO
1) Go to "Component Inspection" Procedure.