Component Inspection

Component Inspection

1. Check PCSV
(1) IG "OFF" and disconnect PCSV connector.
(2) Measure resistance between terminals 1 and 2 of PCSV connector. (Component side)
A. Specification :









(3) Is the measured resistance within specification?
YES
- Substitute with a known-good ECM and check for proper operation.
- If the problem is corrected, replace ECM and go to "Verification of Vehicle Repair" procedure.
NO
- Substitute with a known-good PCSV and check for proper operation.
- If the problem is corrected, replace PCSV and go to "Verification of Vehicle Repair" procedure.

CAUTION:
There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by ECM. After testing ECM on the vehicle, use this function to reuse the ECM on the others