Operation CHARM: Car repair manuals for everyone.

Monitor Scantool Data





Monitor Scantool Data

1. Connect scantool to data link connector (DLC)
2. Engine "ON".
3. select "D RANGE" and drive vehicle.
4. Monitor the "TORQUE CONVERTER (DAMPER) CLUTCH" parameter on the scantool
A. Specification : Calculated slip (engine speed-input speed) < 100 rpm
















5. Is "TCC SLIP (DAMPER CLUTCH SL. RPM)" within specifications?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was repaired and PCM/TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "verification of vehicle repair" procedure
NO
1) Go to "Component Inspection" procedure