Operation CHARM: Car repair manuals for everyone.

Monitor Scantool Data





Monitor Scantool Data

1. Connect scantool to data link connector (DLC)
2. Engine "ON".
3. Monitor the "TCC SOL. VALVE" parameter on the scantool
4. Select "D RANGE" and Operate the vehicle 5th gear
5. Check "TCC SOL. VALVE" parameter value changes while driving
















6. Does "TCC SOLENOID DUTY" follow the reference data?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was repaired and PCM/TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "verification of vehicle repair" procedure
NO
1) Go to "W/Harness Inspection" procedure