W/Harness Inspection
Terminal and Connector Inspection
1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.
3. Has a problem been found?
YES
1) Repair as necessary and go to "Verification of Vehicle Repair" procedure
NO
1) Go to "Position Encoder 2 output harness Signal Inspection" procedure.
Position Encoder 2 output harness Signal Inspection
1. Engine : Idling.
2. TCCU connector : Connect.
3. Measure Signal between terminal 09 of TCCU connector [M41] and chassis ground.
4. Measure Signal between terminal 20 of TCCU connector [M41] and chassis ground.
5. Select Mode Switch to 2H -> 4H -> 4L Mode.
A. Specification : Signal Waveform
CAUTION:
The above value is only for reference. The actual value may differ from it according to various engine condition.
6. Is Position Encoder2 display near the specified value?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or TCCU's connector or was repaired and TCCU memory was not cleared.Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure
NO
1) Go to "Position Encoder 2 output harness short circuit to ground inspection" procedure.
Position Encoder 2 output harness short circuit to ground inspection
1. Ignition OFF.
2. TRANSFER SOLENOID & MOTOR connector : Disconnect.
3. Measure resistance between terminal 9 of TRANSFER SOLENOID & MOTOR harness connector [M41] and chassis ground.
A. Specification : Infinite
CAUTION:
The above value is only for reference. The actual value may differ from it according to various engine condition.
4. Is resistance display near the specified value?
YES
1) Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.
2) Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Check for short to ground circuit of output harness.
2) Repair as necessary and then go to "Verification of Vehicle Repair" procedure.