Operation CHARM: Car repair manuals for everyone.

W/Harness Inspection





Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.
3. Has a problem been found?
YES
1) Repair as necessary and go to "Verification of Vehicle Repair" procedure
NO
1) Go to "CAN comm. Line Inspection" procedure.
CAN comm. Line Inspection
1. IG "OFF" & ENG "OFF"
2. TCCU connector : Disconnect.
3. Measure resistance between terminal "05" of the TCCU harness connector and terminal "06" of the TCCU harness connector.
A. Specification : Approx. 60 Ohms





CAUTION:
The above value is only for reference. The actual value may differ from it according to various engine condition.


4. Is resistance display near the specified value?
YES
1) Fault is intermittent caused by open or short in CAN signal harness was repaired and TCCU memory was not cleared. Go to the applicable troubleshooting procedure.
NO
1) Check for open or short in TCCU communication circuit.
2) Check PCM, ABS, ESP or their signal.
3) Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.