Repair Procedures

REPLACEMENT

1. Disconnect the negative (-) battery terminal.
2. Remove the crush pad.
3. Remove the cowl cross bar assembly.
4. Remove the evaporator & blower unit.
5. Disconnect the connectors from the intake actuator, the blower motor and power mosfet.




6. Remove the intake duct assemble (A) from the heater unit after loosening a mounting bolt and 4 screws.





NOTE:
Make sure that there is no air leaking out of the blower and duct joints.

7. Remove the lower case(A) from the evaporator & blower unit assembly after unscrewing 8screws.




8. Remove the evaporator core(A).




9. Installation is the reverse order of removal.