Component Inspection

Component Inspection

Check "TURBINE SENSOR 2"
1. Ignition "ON" & Engine "OFF".
2. Connect the "C106-3" connector
3. Measure Frequency between terminal "6" of the C106-3 harness connector and chassis ground.
A. Specification :






CAUTION:
Scan tool data link cable is maintain to connecting condition.





4. Is frequency within specifications?
YES
1) Go to "CHECK TCM" as below
NO
1) Replace "TURBINE SENSOR" as necessary and Go to "verification of vehicle repair" procedure
Check TCM
1. Ignition "ON" & Engine "OFF".
2. Disconnect "C106-3" connector.
3. Install scantool and select a SIMI-SCAN,
4. Simulate frequency to TURBINE SENSOR 1 signal circuit.




5. Is "TURBINE SENSOR 1" signal value changed according to simulation frequency?
YES
1) Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Substitute with a known-good TCM and check for proper operation. If the problem is corrected, replace TCM as necessary and go to "Verification of Vehicle Repair" procedure.