Inspection/Repair

Component Inspection

1. Disconnect "C106-2" connector.
2. Ignition "OFF".
3. Measure resistance between terminal "3" of the C106-2 harness connector and chassis ground.
A. Specification : approx. 3-9 Ohms




4. Is resistance within specifications?
YES
1) Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Check for open or short in harness. Repair as necessary and Go to "verification of vehicle repair" procedure
2) If signal circuit in harness is OK, Replace "H &LR/C SOLENOID VALVE" as necessary and Go to "verification of vehicle repair" procedure