Operation CHARM: Car repair manuals for everyone.

Component Inspection





Component Inspection

1. IG "OFF" & ENG "OFF"
2. FRRD connector : Disconnect.
3. Measure resistance between terminal 01, 02 of FRRD connector [E51] and chassis ground (Component side).
A. Specification : Approx 30-40 Ohms.





CAUTION:
The above value is only for reference. The data from vehicle may differ from it according as various vehicle condition. This inspection is for checking open or short of EMC coil.


4. Is resistance display near the specified value?
YES
1) Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.
2) Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Check "FRRD" for contamination, deterioration or damage.
2) Substitute with a known-good "FRRD" and check for proper operation. If the problem is corrected, replace "FRRD" and then go to "Verification of Vehicle Repair" procedure.