Repair Procedures

REMOVAL AND INSTALLATION

1. To remove the sunroof, first remove the following parts :
(1) Overhead console lamp
(2) Sunvisor and assist grip handle
(3) Pillar trims
2. Remove sunroof glass.
(1) Remove screw (6).




3. Disconnect drain hose.




4. Remove sunroof assembly.
(1) Remove bolt and nut.

NOTE:
When removing the sunroof assembly, carefully pull out the sunroof assembly to avoid damage to the other parts.





CHECK OPERATING CONDITION AFTER INSTALLATION

1. Make sure the battery is fully charged.
2. Make sure that the sunroof sliding unit is free of abrasive materials.
3. Make sure that, when the glass panel opens, the rear of the panel does not jam against the roof panel. If there is interference, fully open the glass panel and move the stopper forward.

NOTE:
If the stopper is moved forward too far, it may cause malfunction or leaks. Make sure the gap between the glass panel and roof panel is not more than 0.3 mm (0.012 in.)

4. Measure the driving force of the motor, and adjust it to 15-25 kg (33.1-55.7 lb) with the torque adjustment nut on the motor.




5. After adjustment, be sure to lock the nut with the pawl washer.