Scantool Diagnostics

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC).
2. Warm up the engine to normal operating temperature.
3. Monitor the "CAN" parameters on the scantool.
- Check "Transaxle type, Torque control request, etc" at the ECU service data mode.
- Check "TPS", "rpm", and "Idle Status" parameters among TCU's current data. (AT vehicle only)
A. Check "Transaxle type, Torque control request, etc" at the ECU service data mode.
B. Check "TPS, rpm, IDLE STATE, etc" at the TCU service data mode.
4. Are the parameters displayed correctly ?