Fluid - A/T: Service and Repair

Inspection And Adjustment

Procedure Of ATF Level Adjustment
1. Park the vehicle on a flat load and lock the tires.
2. Shift the shift lever to "P" range.
3. Using a TORX wrench, remove the filler plug (A).




4. If ATF does not drop, add ATF until it drops.

Specified ATF :Shell M-1375.4

5. Using a TORX wrench, install the filler plug.

Tightening torque :35 Nm(3.5 kgf.m, 25.3lb-ft)

6. Start the engine.
7. Shift through all ranges (P-R-N-D-3). Stay in each range for more than 3 seconds.
Then return to "P".

NOTE:
Use the sport mode to shift to "3".

8. Wait until ATF temperature has reached at 30 - 35°C(86 - 95°F).

CAUTION:
Do not raise ATF temperature by "Stall test"

9. Using a TORX wrench (8mm), remove the filler plug.
10. Check for ATF flow from the overflow hole. Add ATF as needed until fluid flows from the overflow hole.

Specified ATF :Shell M-1375.4

11. Check that the ATF flows out of the overflow hole at 30 - 50°C(86 - 122°F).

CAUTION:
Be careful not to exceed 50°C(122°F) of the oil temperature.

12. Using a TORX wrench, install the filler plug.

Tightening torque :35 Nm(3.5 kgf.m, 25.3lb-ft)