Scantool Diagnostics

C1237 Primary Pressure Sensor-Signal

Scantool Diagnostics - Monitor Scantool Data

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & Engine "ON".
3. Press the brake pedal.
4. Monitor the "Pressure Sensor" parameter on the Scantool.

Specification : Approx. 60 bar ~150 bar (There is difference in displayed parameter according to braking force)




Fig 1) Normal data at pressing the break pedal (There is difference in displayed parameter according to braking force)
5. Whenever brake pedal is pushed down, is the pressure sensor's scantool data changed?