Power Seat Motor: Service and Repair

REPLACEMENT

FRONT HEIGHT MOTOR
1. Disconnect the negative (-) battery terminal.
2. Remove the seat cushion .
3. Remove the front height motor (A) after loosening the mounting nuts (2EA) , bolt (1EA) and removing connector.

4. Installation is the reverse of removal.

REAR HEIGHT MOTOR
1. Disconnect the negative (-) battery terminal.
2. Remove the seat cushion .
3. Remove the rear height motor (A) after removing the mounting bolt (2EA) and connector.

4. Installation is the reverse of removal.

SLIDE MOTOR
1. Disconnect the negative (-) battery terminal.
2. Remove the seat cushion .
3. Remove the slide motor (A) after removing the mounting bolt (2EA) and connector.

4. Installation is the reverse of removal.

RECLINING MOTOR
1. Disconnect the negative (-) battery terminal.
2. Remove the seat back .
3. Remove the seat shaft fixing clip (A) and seat shaft (B).

4. Remove the relining motor (A) after removing the mounting nut (1EA) and connector.

5. Installation is the reverse of removal.

INSPECTION

SLIDE MOTOR LIMIT SWITCH
1. Disconnect the limit switch and operate the limit switch.
2. Check for continuity between the terminals.
3. Make sure that the seat operation is normal in the reverse after the maximum operation.
4. If operation is not correct, replace the limit switch.

POWER SEAT MOTOR
1. Disconnect the connectors for each motor.
2. With the battery connected directly to the motor terminals, check if the motors run smoothly.
3. Reverse the connections and check that the motor turns in reverse.
4. If operation is not correct, replace the motors.