Component Tests and General Diagnostics

On-vehicle Inspection

Spark Test
1. Remove the ignition coil connector (A).





NOTE:
When removing the ignition coil connector, pull the lock pin(A) and push the clip(B).





2. Remove the ignition coil(A).




3. Using a spark plug socket, remove the spark plug.
4. Install the spark plug to the ignition coil.
5. Ground the spark plug to the engine.




6. Check if spark occurs while engine is being cranked.

NOTE:
To prevent fuel being injected from injectors while the engine is being cranked, disconnect the fuel pump connector.
Crank the engine for no more than 5 - 10 seconds.

7. Inspect all the spark plugs.
8. Using a spark plug socket, install the spark plug.
9. Install the ignition coil.
10. Reconnect the ignition coil connector.





Inspect Spark Plug
1. Remove the ignition coil connector (A).





NOTE:
When removing the ignition coil connector, pull the lock pin(A) and push the clip(B).





2. Remove the ignition coil(A).




3. Using a spark plug socket, remove the spark plug.

CAUTION:
Be careful that no contaminates enter through the spark plug holes.

4. Inspect the electrodes (A) and ceramic insulator (B).




Inspection Of Electrodes





5. Check the electrode gap (A).

Standard :1.0 - 1.1 mm (0.0394 - 0.0433 in.)





Inspect Ignition Coil
1. Measure the primary coil resistance between terminals (+) and (-).





Standard value:0.62Ohms ± 10%

Removal and Installation

Ignition Coil
1. Remove the engine cover.
2. Disconnect the ignition coil connector (A).





NOTE:
When removing the ignition coil connector, pull the lock pin(A) and push the clip(B).





3. Remove the ignition coil (A).




4. Installation is the reverse of removal.