General Information

P2009 Intake Manifold Runner Control Circuit Low (Bank 1)

General Information

Component Location





General Description

The Variable Charge Motion Actuator (VCMA) is used to adjust a valve (flap) in the intake runner for each cylinder. The valve does not close off the runner but restricts in such a way as to cause turbulence (swirl) in the air fuel mixture. The turbulence in the air will reduce emissions under cold start condition. The valve is operated by a worm gear type driver which doesn't open for limp home mode in the case of loss of current supply. (It doesn't have a return spring). The system also has a Valve Position Sensor (VPS) to supply a feedback of the valve position to the PCM.

DTC Description

If VCM command signal circuit is open or short to ground, PCM determines that a fault exists and a P2009 DTC is stored.

DTC Detecting Condition





Diagnostic Circuit Diagram





Signal Waveform & Data








Fig 1) Normal waveform of VCM actuator (OPEN)
Fig 2) Normal waveform of VCM actuator (Closed)