Cylinder Head Assembly

Cylinder Head

Install cylinder head bolts.

Do not apply engine oil on the threads and under the heads of the cylinder head bolts.

Using SST(09221-4A000), install and tighten the cylinder head bolts and plate washers, in several passes, in the sequence shown.

CAUTION: Always use a new cylinder head bolts.

Tightening torque

Head bolt 37.3 - 41.2 N.m (3.8 - 4.2 kgf.m, 27.5 - 30.4 lb-ft) + (118 - 122°) + (88 - 92°)
Bolt (A) 18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)














SURFACE VARIATION - WARPAGE







Camshaft Bearing Cap

Install the LH/RH camshaft bearing cap (A) and thrust bearing cap (B).

Tightening torque
1st step 5.8 N.m (0.6 kgf.m, 4.3 lb-ft)
2nd step 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)










CAUTION: Be sure to install the thrust bearing cap bolts and the bearing cap bolts in the correct place.

NOTE: Be careful the right, left bank, intake, exhaust side before assembling.




A : L(LH), R(RH)
B : I(Intake), E(Exhaust)
C : Journal number
D : Front mark


For Intake Manifold specifications, refer to Specifications. Specifications

For Exhaust Manifold specifications, refer to Specifications. Specifications

For Camshaft Gear/Sprocket specifications, refer to Specifications. Specifications