Rear Door Window Glass: Service and Repair

Glass Replacement

1. Remove the following parts.
A. Door trim
B. Door belt weatherstrip
C. Door delta molding
2. Remove the glass mounting plug hole (A).

CAUTION:
- Using the door switch to align the mounting hole with the hole on the door glass.
- If it is impossible, align the hole by hand after removing the motor.
- Be careful not to drop to glass and scratch the glass surface.

3. Carefully adjust the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)




4. Installation is the reverse the removal.

NOTE:

A. Roll the glass up down to see if it move freely without binding
B. Adjust the position of the glass as needed.
C. Make sure the door locks/unlocks and opens/closes properly.
D. Replace ant damaged clips.