Repair Procedures

Replacement

NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not bend or scratch the cover and other parts.

1. After loosening the mounting screws, then remove the rear combination lamp (A).
2. Push the lock pin, disconnect the connector (B).




3. Loosen the side's mounting screws.




4. Disconnect the mounting clips and screw.




5. Push the lock pin, disconnect the rear bumper main connector (B).




6. After loosening the mounting bolts, then remove the rear bumper (A).




7. Installation is the reverse of removal.

NOTE:
- Make sure the connector is plugged in properly.
- Replace any damage clips.