Quality Check Procedure

Start engine and observe the following:

1. The "Check Engine" light remains out.

2. Idle speed smoothness once stabilized.

3. Switch on the A/C and note idle speed compensation.

4. Rev the engine - no misfire should be noted.

5. Select drive and note idle speed compensation (brakes applied).

Replace the ECU if the vehicle fails any part of the above procedure.

Otherwise:

6. Attach new label

7. Attach "Green dot" sticker

8. Install ECU and seat base trim panels.





9. After cleaning the surface, complete and affix a Service Campaign label to the vertical surface of the radiator support panel next to the green Emissions Label. Spray the label with a clear acrylic coating (such as Krylon 1301) for weather durability.