Built In Test Procedure

The handset should be detached from the key ring to allow perimetric testing. The system will automatically switch to volumetric testing if the handset is in close proximity to the Ignition Switch (X134).

The built in test procedure is accessed as follows:
1. Starting conditions: ignition OFF, doors unlocked, alarm disarmed, bonnet switch depressed.
2. Carry out instructions 3 to 7 within 2 seconds.
3. Release bonnet switch.
4. Switch ignition ON.
5. Open driver's door.
6. Switch ignition OFF.
7. Switch ignition ON.

If alarm is correctly accessed, the horns will sound briefly and the Theft Alarm LED and hazard lamps will flash. The following checks can then be made:

Perimetric Testing
1. Open and close driver's door or tailgate - Theft Alarm LED and Hazard lamps will flash.
2. Depress and release bonnet switch - Theft Alarm LED and Hazard lamps will flash.
3. Pull the driver's door sill button up - Theft alarm LED and Hazard lamps will flash.
4. Turn driver's door key lock cylinder - Theft Alarm LED and Hazard lamps will flash.

Volumetric Testing
1. Press the unlock button on the handset or move the handset close to the Ignition Switch (X134) to disable perimetric testing and enable volumetric testing.
2. Any movement within the vehicle will be detected by the Alarm Sensor (X213) and indicated by flashing the Theft Alarm LED and hazard lamps.
3. Turn off ignition to end test procedure.