Antitheft and Alarm Systems: Testing and Inspection

NOTE: The handset should be detached from the key to allow perimetric testing of the alarm system. The system will automatically switch to volumetric testing if the handset is in close proximity to the starter switch.

The built-in test procedure can be accessed providing the following conditions exist:
Alarm disarmed.
Ignition off.
Doors unlocked.
Bonnet[hood] closed.

The test mode can be entered by completing the following instructions within 5 Seconds:
1. Open bonnet.
2. Turn starter switch on.
3. Open driver's door (far enough to activate switch).
4. Turn starter switch off.
5. Turn starter switch on.

If the test mode has been correctly accessed, the sounder/horn will operate briefly and the anti-theft alarm indicator and hazard warning lights will flash.

Perimetric tests
The anti-theft alarm indicator light and the hazard warning lights will flash when:
1. Door switches are activated;
2. The bonnet is opened;
3. Sill switches are activated;
4. Key switches are activated.

NOTE: Operation of key switches can be verified by turning the key in the relevant direction so as not to simultaneously activate the sill switch. If the key switch changes state, the change should be detected but the sill switch will not be activated.

Volumetric tests
Press the unlock button or move the handset close to the starter switch to disable perimetric testing and enable volumetric testing. If movement is detected within the vehicle by the ultrasonic sensor it will be indicated by flashing the anti-theft alarm indicator and hazard warning lights.

NOTE: Exit anti-theft alarm built-in test by turning starter switch to the off position.