Monitors, Trips, Drive Cycles and Readiness Codes
DRIVE CYCLE - ADVANCED EVAPS1. Switch on ignition for 30 seconds.
2. Ensure that coolant temperature is less than 140°F (30°C).
3. Start engine and allow to idle for 2 minutes.
4. Perform 2 light accelerations (0 to 35 mph with light pedal pressure).
5. Perform 2 medium accelerations (0 to 45 mph with moderate pedal pressure).
6. Perform 2 hard accelerations (0 to 55 mph with heavy pedal pressure).
7. Cruise at 60 mph for 5 minutes.
8. Cruise at 50 mph for 5 minutes.
9. Cruise at 35 mph for 5 minutes.
10. Allow engine to idle for 2 minutes.
11. Connect TestBook and check for fault codes.