Shiftlock Solenoid/Neutral Switch Replacement

NOTE:
^ This is sited on top of the transfer gearbox.
^ Access to the component is gained through the transmission tunnel aperture.

REMOVAL
1. Disconnect battery negative lead.
2. Remove center console, refer to Body and Frame.
3. Remove rear passenger heater air ducts.
4. Remove insulation pad.
5. Remove four screws and remove main gear lever assembly.
6. Drill out rivets and remove tunnel blanking plate.
7. Disconnect solenoid muitiplug.
8. Remove four retaining bolts and remove shiftlock solenoid cover.
9. Remove solenoid and spring washer.
10. Clean joint sealant from mating faces.

INSTALLATION
1. Apply Hylosil or equivalent sealant to mating faces.
2. Ensure solenoid plug lead is located in cover recess.
3. Reverse removal procedure.
4. Install four solenoid bolts.
- Tighten to 9 Nm.

NEUTRAL SWITCH, AUDIBLE ALARM
1. Disconnect neutral switch electrical plug.
2. Remove neutral switch from transfer box.
3. Apply Hylomar PL32/L20 or SL500 sealant to neutral switch.
4. Reverse removal procedure.
5. Switch, tighten to 25 Nm.